Climadiff CVV265 Gebrauchsanweisung Seite 33

5. EQUIPMENT
The ventilation system: Charcoal filter
PURE AIR continually changed and filtered.
Your Climadiff wine cellar is equipped with a continuous fresh air system, filtered by a charcoal filter. This is
a 5 cm diameter black plastic washer in the top left of the cellar at the back. It should be replaced annually
and can be bought from the accessories section of our web site at www.climadiff.com.
To remove it, push it inwards and do not be afraid to tap it a little to break its seal with the insulation. Finish
removing it by putting your hand behind the evaporator cover. The hole visible in the rear lower section is
normal and provides negative pressure, to ensure internal air circulation.
Direction for removal View from the back of the cellar View from inside
The anti-vibration system
Wine does not like to be disturbed. It especially dislikes vibration. This is why your wine cellar's slow-cycle
compressor is mounted on special shock absorbers called "silent blocks".
Likewise, the inner container is insulated from the body by a thick layer of polyurethane foam which also has
the particular feature of absorbing vibration.
Depending on the model, the wine bottle shelves are made of solid wood and absorb vibration better than
metal. On some models, the shelf supports are also equipped with rubber pads. Your bottles are enjoying
perfect peace!
Hygrometry
Your Climadiff cellar is equipped with a dynamic humidity system, which regulates the humidity level in the
cabinet entirely automatically. No addition of water is required.
It is necessary to wait a few days after start-up for the average (between 55 and 70%) to stabilise in the
cabinet. Frost will form at the bottom of the cabinet: no cause for worry, this is a normal phenomenon, which
may appear when the appliance is used for the first time during the hotter periods of the year and which will
disappear when the natural inertia level is reached.
The winter system (optional on some models)
The winter kit is a frost protection system which enables the cellar to operate in an environment where the
temperature is between 0 and 32°C. A sensor located outside the appliance triggers a low power electrical
element when the ambient temperature in the room falls to around 8°C in case. This is a low power element
to avoid sudden rises in the temperature of the wine and so avoid thermal shocks that are damaging to the
preservation of the wine. The kit is intended to raise the cellar's internal temperature even before there is a
thermal exchange with the bottles.
IMPORTANT: If the temperature in the room where your wine cellar is located is about 12ºC (± 2°C),
no production of warm or cold air will be observed. The appliance is then completely silent and this
is quite normal. It should not be considered as a malfunction.
33