Electrical Connection; Changing The Opening Direction Of The Doors - Bosch ksv 32320 ff Gebrauchsanweisung

9000132870.qxd 27/10/05
Before reading the instructions, turn to the
illustrations on the last page.
Installation
• Install your combined freezer-refrigerator
in a dry, well ventilated room. In a damp
room the moisture in the air will form
condensation on the outside of the
appliance.
• If the unit is placed next to a heat source
or another refrigerator, then the following
minimun lateral clearances must be
maintained (or an insulating panel used):
from electric cookers
from oil or coal-fired cookers
from other refrigerators
• Since warm air generated at the back of
the refrigerator must be allowed to
escape unhindered, you must never
block the space between it and the wall
nor cover the ventilation grid at the base.
• The appliance must stand firm and level.
To compensate for any uneveness in the
floor set the ajustable feet at the front, fig
! ! 4 . Two rollers underneath the appliance
allow it to be easily positioned in a niche.

Electrical connection

• The refrigerator must be connected to a
220-240 V AC (50Hz) supply only, and
must be protected by a 13 Amp fuse. The
connection must be made via a properly
installed socket with a non-fused earthing
contact.
Our contribution towards a cleaner
environment - we use recycled paper.
13:00 Page 29
3 cm.
30 cm.
2 cm.
Changing the opening
direction of the doors
Before carrying out this operation,
disconnect the appliance from the mains
by unplugging it or removing the fuse.
To unplug, pull the plug, not the lead.
Fig.! 5
Take off the cover 9. Remove the lower
protector strip 11 by holding each side and
gently pulling it towards you. Unscrew the
lower door hinge 4, and hinge 5, and
remove the refrigerator compartment
door 3.
Unscrew the door hinge 1, and remove
the freezer compartment door 8. Remove
the plastic plugs 12 (two pieces) from the
opposite side, and press them into their
previous position in the door hinge 1.
Remove the cover 10. Undo the upper
hinge pin 2 and fix it on the opposite side.
Fit the freezer door 8 onto the upper
hinge pin 2, and fix it to its hinge 1. Do not
forget to use adjusting washers between
the refrigerator door 8 and its hinge 1.
Undo the upper hinge pin 4 and fix it on
the opposite side.
Fit the refrigerator compartment door 3
onto its hinge pin 1 and screw it to hinge
4. Do not forget to use adjusting washers
between the refrigerator compartment
door 3 and its hinge 4. Screw the door to
the hinge 5 of the opposite side.
Press the lower protector strip back on 11.
Dismantle the plastic cover and remove
the screw that holds the handle in place
6. Slide the handle 7 to the left and pull it
out, as shown in points 1-2 of Fig. ! 5 .
Assemble the handle on the other side
by performing the reverse of the
operation just described. Place the
plastic cover in the hole that is left after
having changed the position of the
handle.
en
29