Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
EN.qxd
5/12/03
12:17
en
Switching on the
appliance
Fig. W
Refrigerator and freezer compartments
can be switched on separately.
• Press the On/Off button (1)
switch on the refrigerator
compartment. The light inside the
refrigerator compartment switches on
when the door is open.
• Press the On/Off button (7)
switch on the freezer compartment.
• Warning display, Fig. W/5, illuminates
until the operating temperature has
been reached.
Selecting the
temperature
Fig. W
The following standard settings have
been set at the factory:
Refrigerator compartment
temperature
Freezer compartment
temperature
The set values can be changed, see
Description of control panel:
2
Set refrigerator compartment
temperature
4
Set freezer compartment tempera-
ture
20
Page 20
to
to
–20 ºC
Operating tips
• The sides of the housing are
sometimes heated slightly. This
prevents condensation in the area of
the door seal.
• While the refrigerating unit is running,
beads of water or hoarfrost form at the
back of the refrigerator compartment.
This is quite normal. It is not
necessary to scrape off the frost or
wipe off the beads of water. The rear
panel defrosts automatically. The
condensation is conveyed down the
drainage channel, Fig. I/A, to the
refrigerating unit where it evaporates.
• If the air humidity is high,
condensation may form in the
refrigerator compartment, especially
on the glass shelves. If this is the
case, pack or wrap the food and select
a lower temperature in the refrigerator
compartment.
• If you cannot open the freezer
compartment door immediately after
closing it, wait 2–3 minutes until the
partial vacuum has equalised.
• The refrigeration system may cause
several areas of the freezer shelves to
+4 ºC
frost quickly. This does not affect
function or power consumption.
The appliance does not require
defrosting until the entire surface of
the freezer shelf is covered with more
than 5 mm of frost or ice.
Werbung
Inhaltsverzeichnis
