Specifications; General Safety Rules - Makita 9741 Betriebsanleitung

ENGLISH
1. Wing nut
2. Front roller
3. Switch trigger
4. Lock button
5. Spindle
6. Wheel

SPECIFICATIONS

Wheel size (Diameter x Width)
No load speed (min
Dimensions (L x W x H)
• Due to our continuing program of research and development, the specifications herein are subject to change without
notice.
• Note: Specifications may differ from country to country.
Symbols
The following show the symbols used for the tool. Be sure
that you understand their meaning before use.
............... Read instruction manual.
................ DOUBLE INSULATION
Only for EU countries
Do not dispose of electric equipment together with house-
hold waste material!
In observance of European Directive 2002/96/EC on
waste electrical and electronic equipment and its imple-
mentation in accordance with national law, electric equip-
ment that have reached the end of their life must be
collected separately and returned to an environmentally
compatible recycling facility.
Intended use
The tool is intended for removing paint with slit paper
wheel and fine metal cleaning with wire brush wheel.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated in accordance with European Standard
and can, therefore, also be used from sockets without
earth wire.
Explanation of general view
7. Output shaft
8. Hex wrench
9. Notch
10. Pin
11. Dust port
12. Cover plate
Model
-1
)
Net weight
Safety class
13. Joint
14. Grip
15. Handle
16. Limit mark
17. Screwdriver
18. Brush holder cap
100 mm x 120 mm
310 mm x 185 mm x 182 mm

GENERAL SAFETY RULES

WARNING:
Read all instructions. Failure to follow all instructions
listed below may result in electric shock, fire and/or seri-
ous injury. The term "power tool" in all of the warnings
listed below refers to your mains-operated (corded) power
tool or battery-operated (cordless) power tool.
SAVE THESE INSTRUCTIONS
Work area safety
1. Keep work area clean and well lit. Cluttered and
dark areas invite accidents.
2. Do not operate power tools in explosive atmo-
spheres, such as in the presence of flammable liq-
uids, gases or dust. Power tools create sparks which
may ignite the dust or fumes.
3. Keep children and bystanders away while operat-
ing a power tool. Distractions can cause you to lose
control.
Electrical safety
4. Power tool plugs must match the outlet. Never
modify the plug in any way. Do not use any
adapter plugs with earthed (grounded) power
tools. Unmodified plugs and matching outlets will
reduce risk of electric shock.
5. Avoid body contact with earthed or grounded sur-
faces such as pipes, radiators, ranges and refrig-
erators. There is an increased risk of electric shock if
your body is earthed or grounded.
6. Do not expose power tools to rain or wet condi-
tions. Water entering a power tool will increase the
risk of electric shock.
7. Do not abuse the cord. Never use the cord for car-
rying, pulling or unplugging the power tool. Keep
cord away from heat, oil, sharp edges or moving
9741
3,500
4.2 kg
/II
GEA001-3
3