Hella KLED 2.0 Montageanleitung Seite 16

POSSIBLE FLASH SEQUENCES
We recommend
programming the
lamps BEFORE
mounting
them on the roof!
The programming mode allows the
user to select one of the 17 avail-
able fl ash patterns. Flash patterns
1, 2, and 4 are permissible for lamp
POSSIBLE FLASH SEQUENCES
16
1. Single fl ash, 2 Hz
2. Double fl ash, 2 Hz
3. Triple fl ash, 2 Hz
4. Rotating signal, 2 Hz
5. Single fl ash (250 ms off set versus fl ash sequence 1)
6. Double fl ash (250 ms off set versus fl ash sequence 2)
7. Triple fl ash (250 ms off set to fl ash sequence 2)
8. SAE, single fl ash, 1.42 Hz, day level
9. SAE, double fl ash, 1.42 Hz, day level
10. SAE, triple fl ash, 1.42 Hz, day level
11. SAE, quadruple fl ash, 1.42 Hz, day level (light sensor without function)
12. SAE, rotating fl ash, 1.42 Hz, day level
13. SAE, single fl ash, 1.42 Hz, night level
14. SAE, double fl ash, 1.42 Hz, night level
15. SAE, triple fl ash, 1.42 Hz, night level
16. SAE, quadruple fl ash, 1.42 Hz, night level (light sensor without function)
17. SAE, rotating fl ash, 1.42 Hz, night level
operation in Europe only.
FLASH SEQUENCE ADJUSTMENT
1. The lamp must be put in op-
eration (white to positive terminal
(plus +), black to negative terminal
(minus -)).
2. The "Synchronization" input
(yellow) is connected to the positive
terminal (plus +).
(light sensor without function)
(light sensor without function)
(light sensor without function)
(light sensor without function)
(light sensor without function)
(light sensor without function)
(light sensor without function)
(light sensor without function)
3. A er approx. 2 seconds the fl ash
sequence selection
mode is activated, the lamp now
starts fl ashing at approx. 1 Hz. A er
every fl ash cycle, the next fl ash
sequence is activated, although it
always starts with the fi rst fl ash
sequence. For example, if you want
to select the 4th fl ash sequence,
the "Select Flash Sequence" input
(yellow) needs to be disconnected
from positive terminal (plus +) a er
the 4th fl ash.