Specifications - Makita HR3200C Bedienungsanleitung

ENGLISH (Original instructions)
1-1. Switch trigger
2-1. Lamp
3-1. Adjusting dial
4-1. Quick change chuck for SDS-plus
4-2. Change cover
4-3. Chuck cover
5-1. Spindle
5-2. Quick change drill chuck
5-3. Change cover
6-1. Lock button
6-2. Pointer
6-3. Change lever
7-1. Lock button
7-2. Change lever
7-3. Pointer
8-1. Pointer

SPECIFICATIONS

Concrete
Capacities
No load speed (min
Blows per minute
• Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Intended use
The tool is intended for hammer drilling in brick, concrete
and stone as well as for chiselling work.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated in accordance with European Standard
and can, therefore, also be used from sockets without
earth wire.
Noise
The typical A-weighted noise level determined according
to EN60745:
Model HR3200C,HR3210C
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB(A)
Explanation of general view
8-2. Change lever
8-3. Lock button
9-1. Power-ON indicator lamp (green)
9-2. Service indicator lamp (red)
10-1. Side grip
11-1. Bit shank
11-2. Bit grease
12-1. Bit
12-2. Chuck cover
13-1. Bit
13-2. Chuck cover
14-1. Change lever
14-2. Lock button
14-3. Pointer
15-1. Depth gauge
15-2. Clamp screw
Model
Tungsten-carbide tipped bit
Core bit
Steel
Wood
-1
)
Overall length
Net weight
Safety class
) : 89 dB(A)
pA
) : 100 dB(A)
WA
HR3200C
4.8 kg
ENE044-1
Model HR3210FCT
Sound pressure level (L
Sound power level (L
ENF002-1
Uncertainty (K) : 3 dB(A)
Vibration
The vibration total value (tri-axial vector sum) determined
according to EN60745:
ENG905-1
Model HR3200C
Work mode : hammer drilling into concrete
Vibration emission (a
Uncertainty (K) : 1.5 m/s
Work mode : chiseling
Vibration emission (a
Uncertainty (K) : 1.5 m/s
4
16-1. Dust cup
18-1. Blow-out bulb
20-1. Chuck adapter
20-2. Keyless drill chuck
21-1. Spindle
21-2. Quick change drill chuck
21-3. Change cover
22-1. Sleeve
22-2. Ring
23-1. Screws
24-1. Connector
25-1. Crank cap cover
25-2. Screws
26-1. Screws
29-1. Connector
HR3210C
32 mm
90 mm
13 mm
32 mm
315 - 630
1,650 - 3,300
398 mm
5.2 kg
/II
) : 88 dB(A)
pA
) : 99 dB(A)
WA
Wear ear protection
) : 18.0 m/s
h,HD
2
) : 12.5 m/s
h,CHeq
2
HR3210FCT
424 mm
5.4 kg
ENG900-1
2
2