Lenz heat pack 1200 Gebrauchsanweisung Seite 24

O PER A TI N G I N ST R U C T I O N S / E N GL I SH
H O W T O U S E T H E B A T T E R Y P A C K S
 Put on the heatable sock.
 Remove the contact protector from the battery packs (Fig. 1.4).
 Push the battery packs onto the snap fasteners of the socks until they firmly lock into place
(Fig. 3.1).
 Fold over the sock cuff with the battery packs (Fig. 3.2).
 The battery packs can be controlled with the symbol provided on the folded over sock cuff
(Fig. 3.3).
I M P O R T A N T I N S T R U C T I O N S F O R U S E
 The optimal heating power is only reached when the socks, boots or soles are dry.
 Do not operate the device at the highest heating power for longer than several minutes.
 Always set the product to a low or medium heat output to maintain a comfortably warm temperature
(the heater should be virtually unnoticeable).
F U N C T I O N D E S C R I P T I O N
The battery packs have two operating modes: POWER OFF – IN USE. They are revealed by the
heat setting display (Fig. 1.2) on the battery packs. The number of illuminated LEDs corresponds to
the selected heat setting.
POWER-OFF:
 The battery packs are completely turned off and the heat setting display (Fig. 1.2) is permanently
off.
 They can only be switched on with the control button (Fig. 1.3) of the battery packs.
IN USE:
 The battery packs supply the connected sock with energy.
– 22 –