Removal Of The System - Ten-Haaft SamYSolar Montageanleitung

Removal of the system

The removal of the exterior unit requires a 10-mm open-end spanner.
The supply line does not need to be removed.
Proceed as follows:
E
Undo the four M8 nuts securing the base plate to the mounting plate. Lift off
l
the system.
Remove the four M6 nuts at the cover panel below the small white connector
l
housing and pull out the cover panel.
Disconnect the data and power cables by rotating the supply line connectors
l
counter-clockwise.
Disconnect the satellite cable by rotating the connector counter-clockwise.
l
The system can now be removed.
l
To reinstall the unit, perform the steps above in reversed order.
47