Step 5: Connecting The Receiver; Step 6: Tuning The Tv Set To The Receiver - Ten-Haaft SamYSolar Montageanleitung

Step 5: Connecting the receiver

Connect your system to your receiver (not included in scope of supply) by screwing
the F-type connector of the white coaxial cable to the F-type port at the input of
the satellite receiver.
E

Step 6: Tuning the TV set to the receiver

There are two alternatives for the tuning of the TV set to the receiver. Make sure
you follow only either one of the following two instructions!
Either:
Connection via a TV coaxial cable (to be locally procured, not included
in scope of supply), with audio playback in mono only.
First, store the reception channel for the satellite receiver at the TV set. (For the
selection and storing of a channel please refer to the manual of your TV set.) The
system must be switched on to transmit a menu or TV image to the TV set. Now,
start the channel scan at the TV set (refer to TV-set manual). The correct channel
has been found when a picture (menu or TV program) appears on the TV screen.
Store this channel to a pre-programmed station of your choice.
Or:
Connection via a SCART cable to the TV SCART port. This type of
connection facilitates stereo playback.
In this case, the TV coaxial cable provided must not be connected. All you have to
do is to connect the SCART cable to the corresponding SCART ports at the receiver
and the TV set. At the TV set, select channel „AV".
Switch the system off again by pressing the
The antenna unit will then move into the closed position.
key at the control panel.
41