Ten-Haaft SamYSolar Montageanleitung Seite 35

b) Route the cable tidily on the roof of the vehicle (e.g. using a cable duct) and
guide the cable coming out of the threaded elbow fitting downwards to the
control panel.
c) The small mounting plate of the threaded elbow fitting is bonded to the roof
of the vehicle using commercially available body sealing compound and is
E
then secured to the roof with screws. Please use a special cleaning agent to
clean the mounting plate and roof as recommended by the manufacturer of a
highly adhesive body sealing compound (e.g. Sikaflex, Teroson 1K-Pur, Würth
Klebt und Dichtet). Once the cleaner has dried off, apply the sealing
compound to the underside of the mounting plate. After fitting the mounting
plate, secure it to the roof using the 4 supplied self-tapping screws.
Do not tighten the union nut of the elbow fitting before having adjusted the length
of the cable on the roof*.
Dealing of the lead - through roof
Sikaflex on
screws and
screw nuts
Important:
After sealing and drying -
verify the impermeability!
d) Use the sealing compound to seal all around the lower edge of the threaded
elbow joint and the self-tapping screws.
e) The cable can be coiled up if it is too long inside the vehicle.
Check the cable inlet, the self-tapping screws and the foot of the threaded
elbow fitting for leaks.
Sikaflex
all around
*Cabel length to adapt
on the roof
35