Step 1: Installing The Mounting Plate - Ten-Haaft SamYSolar Montageanleitung

Step 1: Installing the mounting plate

Once you have determined the final installation position of the system and you
have checked again that it is correctly positioned in relation to the driving direction
(cable outlet pointing towards the rear of the vehicle), mark the corner points of the
mounting plate.
E
Next, undo the four retaining nuts and lift the system off the mounting plate.
The mounting plate is bonded to the roof of the vehicle using commercially availa-
ble highly adhesive body sealing compound and is then secured by screws. Please
use a special cleaning agent to clean the mounting plate and roof as recommended
by the manufacturer of the body sealing compound (e.g. Sikaflex, Teroson 1K-Pur,
Würth Klebt und Dichtet). Once the cleaner has dried off, apply the sealing com-
pound to the underside of the mounting plate. After fitting the mounting plate,
secure it to the roof using the self-tapping screws provided (see drawing).
Sealing compound
Rear of vehicle Driving direction
Assembly plate
Vehicle roof
Take note of the manufacturer's instructions regarding processing and curing
times of the adhesive sealing compound before moving the vehicle!
33