Ten-Haaft SamYSolar Montageanleitung Seite 39

First connect the branch of the wiring harness to the control panel. The ‚Western'
jack (RJ11 connector) must engage in the control panel with an audible click that
can also be felt.
The black cable which comes out from the cable branch next to the Western jack-
E
cable needs to be connected to the ignition circuit at terminal 15 or D+. These cir-
cuits carry voltage when the ignition is on, and carry no voltage when the ignition
is off. This cable controls some important functions of your SamYSolar+®, hence the
correct connection of this cable must be ensured. You can either route this cable in
the interior, for example to an existing entry-step control system or to a refrigerator
with a corresponding changeover contact, and connect it there. You can also route
the cable together with the battery connection/charging cable to the underfloor
area, where you can connect it at a suitable point to an existing ignition-signal line.
Caution: It is absolutely essential that the system is connected via the black
cable (0.5 mm²) to K15 or D+ of the electric system of your vehicle.
All 5 cables that must be connected to the onboard electric system (2.5 mm²: red,
brown, yellow, black / 0.5 mm²: black) may be shortened to length.
There are two contacts at the cable branch which need to be plugged into the enc-
losed black plastic fuse holder. Ensure that the cable ends click audibly as they latch
in the holder.
Then fit the enclosed 10-A fuse.
Next you need to connect the battery connection/charging cable directly to the
onboard/auxiliary battery.
Caution: Always connect the red and the brown cable of your SamYSolar+®
directly to the terminals of the body/auxiliary battery – never downstream
of any auxiliary equipment. Never connect your SamYSolar+® to the starter
battery.
39