Step 4: Power Supply - Ten-Haaft SamYSolar Montageanleitung

Step 3: Power supply
Your SamYSolar+® is supplied with a perfectly matched cable harness. Do not use
any other wiring except this cable harness to connect the system to the electric
system of your vehicle.
Rear of the vehicle
Elbow connector
Length 4 m from
external unit
Due to the safety regulation of ten Haaft required:
Zündung / Klemme 15
muss angeschlossen werden
!
Zum automatischen Einfahren der Antenne
bei Fahrzeugstart
Ignition switch has to be connected
For automatic retraction of the antenna
at vehicle start
Allumage doit être connecté
Pour rétracter automatiquement l'antenne
au démarrage du véhicule
plug casing
fuse fixing
Length 5m
from branch
connection
Laderegler / Charge controller
Art. No. SR135TL
Laden
charging
>75%
Batteriezustand
battery status
25 - 75%
<25%
Lastzustand
load status
SOLARA
Ignition
Pin 15 / D+
On-board battery
!
siehe Schritt 4 / see step 4 / voir pas 4
38
Driving direction
External unit
Assembly plate
Length 90cm from
branch connection
Western cable
SamYSolar+
Operating control device
Satelitte connection with F-plug
Receiver
(not part of
the delivery)
Note: Instead of the Solara SR 135 charge
controller you may also use an alternative
charge controller of your choice. The solar
lines (black, yellow) must never be connected
directly to the battery. A charge controller
must always be integrated in the line.
E