Ingersoll-Rand EL0410BC–SS–ESD-Serie Bedienungsanleitung Seite 20

7. Tool outputs high torque.
Is the shutoff brake
functioning properly?
Yes
Is Clutch properly lubricated?
Yes
Is there wear on face of cam
guide where it contacts Spindle
Assembly?
No
8. Tool outputs low torque.
Is the Clutch Housing
joint tight?
Yes
TROUBLESHOOTING GUIDE (Continued)
No
No
Yes
No
20
Refer to Problem No. 4 to check shutoff brake
malfunctions.
No lubrication on the Clutch components
Lubricate the Clutch with recommended grease.
Cam guide is worn.
Replace the Bit Holder Assembly.
Clutch Spring is damaged. Replace Spring.
Loose joint between the Gear Case and Clutch
Housing.
Tighten the joint with a torque wrench
to specified torque.
1. Cam is worn.
Replace the Cam.
2. Clutch Spring is damaged.
Replace the Clutch Spring.
Cam guide is damaged.
3.
Replace the Bit Holder Assembly.