Parameters Configuration; Internal Counting (A/D); Configuration Of The Weight Limits (Superior And Inferior); Auto Switch Off - Baxtran SCU Bedienungsanleitung

7. PARAMETERS CONFIGURATION

7.1

INTERNAL COUNTING (A/D)

7.2

CONFIGURATION OF THE WEIGHT LIMITS (SUPERIOR AND INFERIOR)

7.3

AUTO SWITCH OFF

7.4

CONFIGURATION OF THE ILLUMINATION OF THE DISPLAY

7.5 HOLD FUNCTION
7.6 RS-232 DATA EXIT
7.7 CONFIGURATION OF THE SPEED OF THE AD CONVERTER
7.8 BLIND
7.9

CONFIGURATION OF THE GRAVITY

To access the configuration of parameters when the screen is in zero, the user must press the key
Press the key to choose the desired character (UF-1 ~ UF-11).
To go back to the previous mode press the key
7.1 BATTERY VOLTAGE| UF-1
1. Press the key
2. Press the key
3. To exit this mode and go back, the user must press the key
7.2 CONFIGURATION OF THE LIMITS OF WEIGHT ( SUPERIOR AND INGERIOR) | UF-2
1. Press the key
2. The display will show the message " 000.00L " ( inferior limit)
3. Use the keys
4. Once all the digits of the lower limit have been programmed, press the key
5. The display will show the message "000.00h" (Superior limit=
6. Use the key
7. Once all the digits of the high limit have been programmed, press the key
8. The display will show the value.
DISPLAY VALUE
A
B
C
9. Press the keys
10. Press the key
32
.
the screen will show the value of the voltage of the battery.
to access the parameter.
to move the cursor and the key
to move the cursor and the key
ESTABILITY
0 There is no need to stabilize the alarm to make it ring
1 The alarm must be stabilized to ring
0 Always 0
0 Alarm switched off
1 The alarm ring if it is place on the band OK
( between the limits Lo and Hi)
2 The alarm rings if it is situated below the
inferior limit Lo or above the superior limit
Hi
to move the cursor and the key
to confirm.
.
to choose the desired number..
Hi
)
to choose the desired number.
.
A B C
0 0 0
(configuration of the alarm)
LO
LO
to choose the desired number..
USER'S MANUAL SCU
.
OK HI
OK HI
EN