Vaisala HMDW110 Kurzanleitung Seite 19

Vaisala Insight Software
Vaisala Insight PC software can be used to check, configure, and adjust HMDW110 series
transmitters intuitively without typing any serial commands. The transmitter can be connected
to Insight software using a Vaisala USB cable for computer connection (order code 219690).
With the Insight software, you can:
• See device information and status.
• See real-time measurement.
• Configure serial communication settings, filtering factor, and analog output parameters
and scaling.
• Calibrate and adjust the device.
Insight software guides you when changing the settings and performing adjustments on the
transmitter. However, please read carefully the chapters on calibration and adjustment in
HMDW110 Series User Guide (M211726EN) before performing adjustments on your HMDW110
device.
Download Insight software at www.vaisala.com/insight.
HMDW110 transmitters support Insight from transmitter software version 2.2.3
onwards.
Connecting to Insight Software
• Computer with Vaisala Insight software installed
• USB connection cable (order code 219690)
Before connecting the transmitter to a PC:
• If the terminal block for terminals 5 ... 8 is wired, pull it out. This disconnects
the transmitter from supply voltage and prevents possible equipment damage
that may be caused by ground loops. The locations of the terminal blocks and
the service port are shown in
• If the other terminal block is wired (terminals 1 ... 4), pull it out also. This
prevents the communication between the transmitter and the RDP100 remote
display panel or Modbus (RS-485) host from interfering with your connection.
1. Open the Insight software.
2. Connect the USB cable to a free USB port on the PC.
3. Connect the USB cable to the service port of the transmitter.
4. Wait for Insight software to detect the transmitter.
If the transmitter is not detected, disconnect and reconnect the Vaisala USB cable to the
service port connector of the transmitter.
Component Board (page 12).
19