Schumacher SCI90 Benutzeranleitung Seite 7

If the battery is left discharged for an extended period of time, it could become sulfated and
not accept normal charge. If you select
operation designed for sulfated batteries. If successful, the charger will fully desulfate and
charge the battery, then the green LED will go on. If desulfation fails, the charger will abort
and the CHARGING
Completion Of Charge
Charge completion is indicated by the CHARGED
stopped charging and switched to the Maintain Mode of operation.
Maintain Mode
When the CHARGED
the charger keeps the battery fully charged by delivering a small current when necessary.
The voltage is maintained at a level determined by the battery type selected.
NOTE: If the charger has to provide its maximum maintain current for a continuous 12
hour period it will go into Abort Mode. This is usually caused by a drain on the battery or
the battery could be bad. Make sure there are no loads on the battery. If there are, remove
them. If there are none, have the battery checked or replaced.
Maintaining a Battery (3A
This charger has a maintenance setting that maintains both 6 and 12 volt batteries,
keeping them at full charge. On this setting, it can charge small batteries and maintain
both small and large batteries. We do not recommend charging a large battery on the
maintenance setting.
NOTE: The maintain mode technology utilized in Schumacher's chargers allows you
to safely charge and maintain a healthy battery for extended periods of time. However,
problems with the battery, electrical problems in the vehicle, improper connections or other
unanticipated conditions could cause excessive current draws. As such, occasionally
monitoring your battery and the charging process is recommended.
Using the Engine Start feature
Your battery charger can be used to jumpstart your car if the battery is low. Follow these
instructions on how to use the ENGINE START feature.
IMPORTANT
Using the ENGINE START feature WITHOUT a battery installed in the vehicle
could cause damage to the vehicle's electrical system. NOTE: If you have charged the
battery and it still will not start your car, do not use the ENGINE START feature, or it could
damage the vehicle's electrical system.
1. With the charger plugged in and connected to the battery and chassis (see section 6),
press the CHARGE RATE button until the ENGINE START
2. This product is rated for 3 seconds of engine cranking.Crank the engine until it starts
or 3 seconds pass. If the engine does not start, wait 3 minutes before cranking again.
This allows the charger and battery to cool down.
NOTE: During extremely cold weather, or if the battery is under 2 volts, charge the battery
for 5 minutes before cranking the engine.
3. If the engine fails to start, charge the battery for 5 more minutes before attempting to
crank the engine again.
IMPORTANT
Do not leave the charger in Engine Start Mode for more than ten minutes at a
time, or you may damage the charger.
4. Clean and store the charger in a dry location.
NOTE: If the engine does turn over but never starts, there is not a problem with the
starting system; there is a problem somewhere else with the vehicle. STOP cranking the
engine until the other problem has been diagnosed and corrected.
Engine Starting Notes
During the starting sequence listed above, the charger is set to one of three states:
Wait for cranking – The charger waits until the engine is actually being cranked before
delivering the amps for engine start and will reset if the engine is not cranked within 15
minutes. (If the charger resets, it sets itself to the default start up settings). While waiting
for cranking, the digital display shows
Cranking – When cranking is detected, the charger will automatically deliver up to its
maximum output as required by the starting system for up to 3 seconds or until the engine
cranking stops. The digital display shows a countdown of the remaining crank time.
, the charger will switch to a special mode of
(yellow) LED will blink.
LED is lit, the charger has started Maintain Mode. In this mode,
Charge Rate)
.
7
LED. When lit, the charger has
LED is lit.