Rear View; Remote Control - VINCENT SV-226MKII Bedienungsanleitung

REAR VIEW

11
I N P U T
S6 S5 S4 S3 S2 S1
13 14
11. INPUT
Here you can connect up to six source devices
with stereo audio line level output.
12. SPEAKER A/B: Speaker connectors
Output sockets with screw clamps for connection
of two pairs of loudspeakers. You can use loud-
speaker cables with 4 mm banana connectors.
13. REC OUT: Recording output
If desired, you can connect a recording device like
a CD recorder or a tape recorder to this output. The
stereo signal of this output is identical to the output
signal of the selected audio source at one of the
inputs (11). It is independent of the volume setting
(3)(20), the Tone control (5)(6)(8), the Loudness set-
ting (9), the setting of the Speaker switch (4) and the
plugging-in of a headphone (10).
28 Vincent
12
15 16 17
14. PRE OUT: Preamplifier output
With these two pairs of connectors you can con-
nect the preamplified stereo audio signal of the
currently selected source to additional power
amplifier channels or an active subwoofer. The
signal of this output is independent of the "SPEA-
KER A/B" setting (4) and the plugging-in of a
headphone (10).
15. AC 220-240V: Mains connector
To establish the power supply, connect the plugs
of the power cable to the device and to a suitab-
le wall outlet.
16. FUSE HOLDER
This small plastic housing contains the device's
fuse. Note the safety instructions on this.
17. POWER CONTROL (12V)
These jack connectors (3.5 mm) send the signals
for the standby control (12V Trigger).

REMOTE CONTROL

Point the front of the remote control directly at
the front of the appliance, making sure there
are no objects between the remote control and
the appliance.
The distance between the remote control and the
appliance should not be more than 7 m, as the
reliability of the remote control is affected beyond
this range.
BATTERIES
Using batteries
Handling batteries incorrectly can cause battery
acid to escape or an explosion in extreme cases.
The batteries must be correctly inserted taking note
of the polarity, which is marked in the inside of the
battery compartment.
In order to make full use of the batteries' life, do
not mix new and used batteries. Make sure that
you insert batteries of the same type.
Some batteries are rechargeable, others are not
however. Take note of the precautions and instruc-
tions that are included on all batteries.
Remove the batteries if the remote control is not
going to be used for a long time.
Under no circumstances must batteries be short-cir-
cuited, taken apart or heated up.
For environmental reasons, used batteries should
be disposed of in accordance with local environ-
mental regulations and not put with domestic
waste.
Only use AAA (LR3) size batteries.
Make sure that you do not point the remote control
at an angle to the appliance, as beyond an angle
of ±30° to the centre axis the appliance may not
respond as well to the remote control.
Change both batteries if the distance at which the
remote control can be used effectively decreases.
Changing/Inserting batteries:
a) Open and remove the battery compartment lid of
the remote control by tugging sharply on the fishpla-
te on the edge of the remote control. The battery
compartment lid is held in place magnetically, there
is no need to loosen the screws!
a
b) If necessary, remove used batteries and insert
new ones correctly as shown by the diagram in
the battery compartment.
b
c) Put the compartment cover back on and close the
battery compartment.
c
Vincent 29