Rear View - VINCENT SP-996 Bedienungsanleitung

3. LINE IN:
Input for preamplified mono audio signal
This input must be connected with the output
socket of the preamplifier for the desired channel.
For example, connected with "PRE OUT R", if the
SP-996 is to be used for the loudspeaker of the
right-hand stereo channel. Do not connect any
line level sources!
4. SPEAKERS: Loudspeaker terminal
At these output sockets with threaded speaker
clamps one loudspeaker can be connected. Spea-
ker cable with 4 mm banana plugs can be used.
5. AUTO: automatic shutoff
With this switch you can make this main amplifier
switch back into standby automatically 30 minu-
tes after a signal has been detected for the last
time at the socket "LINE IN" (3). This function is
not available in case of a connected Power
Control Cable (6).
Vincent
24
Downloaded from www.Manualslib.com
3
4
5
6
7
manuals search engine

REAR VIEW

6. POWER CONTROL: ON/OFF control
These jack connectors (3.5 mm) receive and for-
ward the signal for the standby control (12V
Trigger). As long as there is a cable connected to
one of the "POWER CONTROL" sockets, the
signal via this cable alone decides whether the
main amplifier is active or in standby mode.
7. AC power connector and fuse holder
To establish the power supply, connect the plugs of
the power cable to the device and to the AC wall
outlet. The small plastic housing beneath the plug
opening holds the fuse. Refer to the security pre-
cautions.