Connect The Ethernet Cable - Cognex In-Sight 7000 Serie Schnellstartanleitung

Connect the Ethernet Cable

1. Attach the Ethernet cable's M12 connector to the vision system's M12 ENET
connector.
2. Connect the Ethernet cable's RJ-45 connector to a switch/router or PC, as
applicable.
Connect the Power and I/O Breakout Cable
Note: Unused bare wires can be clipped short or tied back using a tie made of
non-conductive material. Keep all bare wires separated from the +24VDC wire.
1. Verify that the 24VDC power supply being used is unplugged and not
receiving power.
2. Optionally, connect the I/O or serial wires to an appropriate device (for
example, a PLC or a serial device). Refer to Power and I/O Breakout Cable
Specifications on page 10 for wiring details.
3. Attach the Power and I/O Breakout cable's +24VDC (Red wire) and
GROUND (Black wire) to the corresponding terminals on the power supply.
Refer to Power and I/O Breakout Cable Specifications on page 10 for wiring
details.
CAUTION:
the polarity shown.
4. Connect the Power and I/O Breakout cable's M12 connector to the vision
system's PWR connector.
5. Restore power to the 24VDC power supply and turn it on if necessary.
Never connect voltages other than 24VDC. Always observe
8