Cognex In-Sight 7000 Serie Schnellstartanleitung Seite 8

Install the Lens (C-Mount Configuration)
There are two lens configurations available for the vision system: an M12 lens
configuration and a C-Mount lens configuration. If you purchased a vision system
with the M12 lens configuration, the vision system is shipped with the lens pre-
installed and no additional installation is required. If you purchased a vision system
with the C-Mount lens configuration, you will need to complete the following steps to
install the lens to the vision system.
Note: Autofocus is not supported for the C-Mount lens configuration.
1. Remove the protective cap and the protective film covering the image
sensor, if present.
2. Attach a C-Mount lens to the vision system. The exact lens focal length
needed depends on the working distance and the field of view required for
your machine vision application.
3. If using a lens cover, attach the lens cover to the vision system.
6