Cognex In-Sight 7000 Serie Schnellstartanleitung Seite 4

Precautions
Observe these precautions when installing In-Sight vision systems to reduce the risk
of injury or equipment damage:
The In-Sight vision system is intended to be supplied by a UL or NRTL listed
l
power supply with a 24VDC output rated for at least 2A continuous and a
maximum short circuit current rating of less than 8A and a maximum power
rating of less than 100VA and marked Class 2 or Limited Power Source
(LPS). Any other voltage creates a risk of fire or shock and can damage the
In-Sight components.
Do not install In-Sight vision systems where they are directly exposed to
l
environmental hazards such as excessive heat, dust, moisture, humidity,
impact, vibration, corrosive substances, flammable substances, or static
electricity.
To reduce the risk of damage or malfunction due to over-voltage, line noise,
l
electrostatic discharge (ESD), power surges, or other irregularities in the
power supply, route all cables and wires away from high-voltage power
sources.
Do not expose the image sensor to laser light; image sensors can be
l
damaged by direct, or reflected, laser light. If your application requires the
use of laser light that may strike the image sensor, a lens filter at the
corresponding laser's wavelength is recommended. Contact your local
integrator or application engineer for suggestions.
The In-Sight vision system does not contain user-serviceable parts. Do not
l
make electrical or mechanical modifications to In-Sight vision system
components. Unauthorized modifications may void your warranty.
2