Werbung
Verfügbare Sprachen
Verfügbare Sprachen
• Clean the unit regularly.
• Do not allow children to use the unit as a toy.
• For children safety reasons do not leave polyethyl-
ene bags, used as a packaging, unattended.
• Attention! Do not allow children to play with poly-
ethylene bags or packaging film. Danger of suf-
focation!
• This unit is not intended for usage by children or
disabled persons unless they are given all the nec-
essary and understandable instructions by a person
who is responsible for their safety on safety mea-
sures and information about danger that can be
caused by improper usage of the unit.
• Children and disabled people can use the unit under
supervision only.
• Do not use the unit outdoors.
• Never pull the power cord, when disconnecting the
unit from the mains, take the plug and remove it
carefully from the socket.
• Never use the unit if the power cord or the power
plug is damaged, the unit works improperly or af-
ter it was dropped. Do not try to repair the unit by
yourself. Contact an authorized service center for
all repair issues.
THE UNIT IS INTENDED FOR HOUSEHOLD USAGE
ONLY
USING OF THE COOKING BOWL (3)
• Use the multicooker and its removable bowl (3) for
the intended purposes only. Do not use the cook-
ing bowl (3) with other heating units or cooking
surfaces.
• Do not replace the bowl (3) with any other container.
• Always make sure that the heating element (13)
surface and the bottom of the bowl (3) are clean
and dry.
• Do not use the bowl (3) for mixing products. Never
chop the products in the bowl (3) to avoid damage
of non-stick coating.
• Never leave or keep any foreign objects in the bowl
(3).
• Stir the products in the bowl (3) only with the spat-
ula (17). You can also use wooden, plastic or silicon
accessories.
• Do not use metal objects that can scratch the non-
stick coating of the bowl (3).
• Do not tap on the inner surface of the bowl (3).
• After cooking dishes with spices and seasonings
wash the bowl (3) immediately (see chapter "Clean-
ing and care").
• To avoid damage of the non-stick coating do not put
the bowl (3) into cold water right after cooking; let it
cool down preliminary.
VT-4206.indd 5
• The bowl (3) is not intended for washing in the dish-
washing machine.
Before the first use
1. Unpack the unit, remove any stickers and package
materials that can prevent unit operation.
2. Place the unit on a flat, dry, heat-resistant surface
away from water, moisture and open flame. Distance
to the nearest surfaces should be at least 20 cm.
Attention! Do not place the unit near bath tubs,
kitchen sinks or other containers filled with water.
Note: After unit transportation or storage at low
temperature it is necessary to keep it for at least two
hours at room temperature before switching on.
3. Open the multicooker lid (6) by pressing the but-
ton (2).
4. Remove the protection screen (5) by pressing the
clamps (4).
5. Remove the steam valve (11) (pic. 1) and dissemble
it by turning its lower part in position
6. Wash all the removable parts (steam valve (11), pro-
tection screen (5), bowl (3), steam cooking basket
(19), soup ladle (15), spatula (17) and measuring cup
(16)) with a soft sponge with some neutral detergent,
then rinse with running water and dry.
7. Wipe the unit body with a soft damp cloth. Let the
unit dry.
8. Combine the valve parts by matching ledges on the
lower part with grooves on the upper one and turn
the upper part clockwise till locking (position ).
9. Install protection screen (5) and the steam valve (11)
back to its place.
Using of the multicooker
1. Put the necessary products into the bowl.
Note: Make sure that the products and liquids level
doesn't exceed the maximal mark. The maximal mark
for porridges (except rice) - 3 l, maximal mark for other
products and liquids - "CUP".
2. Place the bowl (3) in the process chamber. Make
sure that the bowl (3) is placed evenly and is in se-
cure contact with heating element (13) surface.
Note:
Do not use the bowl (3) for washing cereals and
chopping products, this can damage the non-stick
coating.
Wipe the outer surface and the bottom of the bowl (3)
dry before use. Make sure that there are no foreign
objects, dirt and moisture in the process chamber and
on the bottom of the bowl.
In the middle of the heating element (13) there is a
temperature sensor (14). Make sure that the movement
of the sensor (14) is not limited.
5
ENGLISH
.
30.05.2013 15:26:05
Werbung
