Grundig WTR 3200 BT Bedienungsanleitung Seite 15

SETTINGS
Notes:
You can choose between numbers, lower and
7
upper case letters, and special characters.
Press » « or » « or by turning the Volume
7
Knob to scroll through the menu pages (num-
bers, letters, special characters, etc.).
If you make a mistake during entry, press
7
» «, » «, » « or » « or by turning the Vol-
ume Knob to select the push button »BKSP«
and press »OK« to confirm. The last charac-
ter is deleted.
If you wish to exit the menu prematurely,
7
press » «, » «, » « or » « or by turning
the Volume Knob to select the push button
»CANCEL« and press »OK« to confirm.
16 Press »OK« to end the setting.
Setting­DAB­stations
Automatic­station­search
If you first switch on the device in DAB mode, the
automatic station search starts.
During the search, the first line shows the num-
ber of stations found, and the second shows the
search scale.
After the end of the search, an alphanumeric ar-
rangement of stations appears. If no stations are
found, the DAB menu appears in the display.
1
To enter DAB mode, either press »Menu« but-
ton --> select "Main menu" --> DAB or press
»Mode/AL« button then turn the Volume knob
clockwise or anticlockwise to scroll left or right
through the mode list until DAB Radio is high-
lighted and press »OK«.
Note:
In the »DAB Radio« – »Full scan« menu, you
7
can restart a new "Automatic station search".
This may be necessary when the location of
the device is changed.
­ - --------------------------------------------------------------------------------------------------------------------------------------
Sorting­channels
You can sort the station list stored during the sta-
tion search in three different ways.
– »Alphanumeric«: all stations are sorted alpha-
numerically (default setting).
– »Ensemble«: all stations are sorted by ensemble.
– »Valid«: active stations are listed first, stations
that are not active are shown with a question
mark.
1 Press »MENU« to open the DAB menu.
2 Select the option »Station order« by pressing »
« or » « or by turning the Volume Knob and
confirm by pressing »OK«.
3 Select your settings by pressing » « or » «
or by turning the Volume Knob and confirm by
pressing »OK«.
Setting­FM­stations
Setting­the­search­mode
There are two different automatic scan setting
modes.
1
To enter FM mode, either press »Menu« but-
ton --> select "Main menu" --> FM or press
»Mode/AL« button then turn the Volume knob
clockwise or anticlockwise to scroll left or right
through the mode list until FM Radio is high-
lighted and press »OK«.
2
Press »MENU« to open the »FM« menu.
3
Select the option »Scan setting« by pressing
» « or » « or by turning the Volume Knob
and confirm by pressing »OK«.
– Display: »Strong stations only?«.
4
Select your setting (»YES« or »NO«) using
» « or » « or by turning the Volume Knob and
confirm by pressing »OK«.
5­Press »MENU« to end the setting.
ENGLISH
15­ ­