Menu Navigation - Grundig WTR 3200 BT Bedienungsanleitung

SETTINGS
Menu­navigation
Press »Menu« on the device or on the remote con-
trol, select »Main menu« using » « or » « or by
turning the Volume knob, and confirm by pressing
the Volume knob or »OK« on the remote control.
If you wish to view the previous menu, press » «
on the remote control.
First­Installation­using­the­instal-
lation­assistant­"Wizard"
When you connect the device to the mains, or af-
ter factory reset, the display will show the Grun-
dig logo. The Wizard installation assistant then
appears, which guides you through the installa-
tion step by step.
Notes:
For Wi-Fi connection, please make sure, that
7
the Wi-Fi router is switched on.
The network name (SSID) must be visible and
7
the MAC address of the device may be en-
tered in the Wi-Fi router.
Perform the registration process in the prox-
7
imity of the router in order to avoid problems
with the Wi-Fi range.
If you wish to use a LAN cable for internet
7
access, the device has to be connected to
the router via LAN cable (see "Connection
and Preparation" section).
Start­First­Installation
1 First switch on the device by pressing »
the remote control or »
– Display: »Setup wizard« menu opens.
2 Select the push button »YES« by pressing »
« or » « or by turning the Volume Knob and
confirm by pressing »OK«.
– Display: »Language« menu opens.
3 Select your preferred language by pressing
» « or » « or by turning the Volume Knob
and confirm by pressing »OK«.
– Display: »Date/Time« menu opens.
­ - --------------------------------------------------------------------------------------------------------------------------------------
8
8 « on the device.
4
Select the hour format »12« or »24« by press-
ing » « or » « or by turning the Volume Knob
and confirm by pressing »OK«.
– Display: »Auto update« menu opens.
5
Select the input source from which the automat-
ic time synchronisation should be performed.
Selection options:
– »Update from DAB«;
– »Update from FM«;
– »Update from Network« (from an Internet
station);
– »No update« (No automatic time synchroni-
sation).
6 Select one of the options by pressing » « or »
« or by turning the Volume Knob and confirm
by pressing on the Volume Knob or »OK« on
the remote control.
– The menu »Set timezone« appears (only if
»Update from Network« was selected).
Note:
If »Update from DAB« or »Update from FM«
7
was selected, continue from point 8.
7 Select the time zone by pressing » « or » «
or by turning the Volume Knob and confirm by
pressing »OK«.
– Display: »Daylight savings« menu opens.
8 Select Daylight savings (for Central Europe) by
pressing » « or » « or by turning the Volume
Knob to select »ON«, and confirm by pressing
»OK«.
« on
Normal time is set using »OFF«.
– The menu »Internet Setup« appears.
9­If the device is to be switched on via the network,
select the »YES« button with » « or » « or by
turning the jog shuttle and confirm with »OK«.
If the device is not to be switched on (low
stand-by power), select the »NO« button with
» « or » « or by turning the jog shuttle and
confirm with »OK«.
– The menu »Wlan region« appears.
ENGLISH
13­ ­