Activating­and­deactivating­the­ Alarm; Sleep Timer - Grundig WTR 3200 BT Bedienungsanleitung

TIMER­MODE
Interrupting­the­alarm
1 Press »OK« while the alarm is sounding.
– Display: 5 minutes
– The alarm (signal tone or radio) stops.
Note:
The alarm will sound again depending on
7
how often a button has been pressed (1 time
= after 5 minutes, 2 times = 10 minutes, 3
times = 15 minutes, 4 times = 30 minutes.
Cancelling­alarm­stand-by
1
Press » 8 « while the alarm is sounding.
– Display: the current time and alarm.
– The alarm (signal tone or radio) stops, but
the alarm function remains activated for the
next day at the same time.
Activating­and­deactivating­the­
alarm
1
Press » 8 « to switch off the device.
2 Press »Mode/AL« to deactivate or reactivate
the alarm stand-by.
Note:­
1 time = alarm1 On, 2 times = alarm 1 On
7
and alarm 2 On, 3 times = alarm 1 Off and
alarm 2 On, 4 times = alarm 1 Off and
alarm 2 Off.
24­ ­ ENGLISH
­--------------------------------------------------------------------------------------------------------------------------
Sleep­Timer
The device has a sleep timer which switches off in
radio mode at a preset time. It is possible to adjust
the sleep time between 15 and 60 minutes in 15
minute increments.
Select­the­switch-off­time­for­the­
sleep­timer
1 Press » 8 « to switch on the device.
2
Press sleep icon on device or remote control
to adjust the sleep time.
– Display: »Sleep off«.
3
Set the switch-off time with »
increments) and confirm by pressing »OK«.
– Display: » «.
Notes:
To check the remaining switch-off time press
7
briefly »Sleep«.
You can set the switch-off time also by
7
pressing » « (in 15 minutes increments).
Switch­off­the­sleep­timer
1 To switch off the sleep timer earlier, press sleep
logo and adjust to »Sleep Timer Off«
and confirm by press »OK«.
­
« (in 15 minutes
r e