Panasonic CS-ME7CKPG Bedienungsanleitung Seite 17

Timer setting of "odour clear" operation
To prevent the growth of mould in the internal section of the air conditioner, the internal sections may be dehumidified via the air
circulation / heating operations.
With a one time setting, the odour clear operation becomes operational on the preset time every day. (Maximum duration: 50
minutes)
Please confirm and synchronize with the current time. When the time display is blinking, setting is not possible.
1
2
3
TO CANCEL THE MODE
1
Press the
"ODOUR CLEAR" appears in the remote control display panel.
2
Press
The odour wash lamp in the indoor unit and odour clear indication in the remote control are disappeared.
NOTE
The "TIMER" can not be set at the same time. If this mode is set when the "TIMER" mode is still active, it will override
and cancel the "TIMER" mode. (The indoor unit's timer lamp will be off) however, the other indoor units that are being
connected to the common outdoor unit, will not be affected and their "TIMER" modes can not be cancelled.
Indoor units having the "Timer setting of odour clear operation" mode set, can not operate on "TIMER" mode. (Even if
the "TIMER" mode is active, the signal to cancel will not be accepted by the unit. There will be "Beep, Beep, Beep,
Beep" audio response.)
NOTE
ODOUR REMOVING • Timer setting of ODOUR CLEAR OPERATIONS:
Operating conditions: Outdoor temperature: 35°C and below,
Indoor temperature : 35°C and below
When the "Timer setting of ODOUR CLEAR OPERATION" mode is active, it is not possible to cancel the operation.
The odour clear mode of all rooms are carried out by setting the odour clear mode one room.
It is normal to hear some "Pish... Batt" noises during operations.
When the indoor temperature rises, there may be some permeation of odour from the unit, thus it is recommended that you
let fresh air in by opening up some windows.
The fan speed • air flow directions are automatically adjusted and are not directly controlled by the remote control. There are
times when the vertical louvres are closed. (Not possible to adjust them)
After this operation ends, the unit will return to the original operating modes: AUTOMATIC • HEATING • COOLING • DRY •
AIR CIRCULATION modes.
Press the button for 6 seconds and above,
until "ODOUR CLEAR" appears on the remote
control display panel.
Press to preset the time
Blocks of 10 minutes are shown each time it is pressed.
Continuously pressing either button will fast forward or
reverse the displayed time blocks.
12 midnight will be displayed as
Press
When the "ODOUR CLEAR" appears on the display panel
of the remote control, "ODOUR REMOVING" is also being
set at the same time.
The operation will start on the preset time and will
automatically end after approximately 50 minutes of
operation, and will return to the original condition.
button for 6 seconds and above only.
Remote control
display panel
.
Odour wash mode lamp
(Green) is on.
Odour wash mode lamp
(Green) blinks
(
Returns to original
condition after 50 minutes
on the preset time
)
17