Wall Mounted - Jacuzzi sasha Vorinstallationsblatt

As soon as you receive the product, check that it is in perfect
condition and if not, immediately notify the forwarding agent.
- All measurements are provided in centimetres
- The reference diagrams are not to scale
Info
The Sasha range is available in the following module combinations:
sauna + shower
hammam + shower
sauna + hammam
sauna + shower + hammam
Single modules are also available:
sauna
hammam
The following installation types are supported (refer also to the
relevant instructions):

WALL MOUNTED

sauna, hammam, sauna + shower, hammam + shower
ref. "a" - with the panel P1 (provided) and the covering panels P
(optional).
The panel P1 closes up the space by the equipment zone ,
whilst the panels P are installed behind the front frame (W).
sauna + hammam, sauna + shower + hammam
ref. "a" - with the covering panels P (optional).
The panels P are installed behind the front frame (W).
all models
ref. "b/c" - without covering panels P.
The cladding system (plasterboard, etc.) can be installed as in-
dicated, it must, however, lean against the front frame (W);
the size of the area is based on the measurements.
It is also possible to install the Sasha appliance away from a
corner of the room (or between corners, ref. "c ") and there-
fore close up the remaining space, so that once the installation
process is complete, the cladding will be positioned behind
the front frame (W) (part F2).
CORNER
sauna, hammam, sauna + shower, hammam + shower
ref. "d" - with the panel P1 (provided).
sauna + hammam, sauna + shower + hammam
ref. "d" - with covering panels P (optional), or with a secondary
cladding system (see ref. "b/c").
ATTENTION: the front frame (W), protruding from the
walls of the appliance, ensures a clearance between
the appliance itself and the wall: this is required to
ensure adequate ventilation.
Ventilation must always be provided!
Do not obstruct the ventilation outlet of the Jacuzzi®
sauna covering panel (P) in any way!
Should you wish to install a panel to close off the front
area of the appliance (between the covering frame
and the ceiling), you must ensure adequate ventila-
tion, as instructed; in addition, you must ensure that
the entire panel is completely removable for inspec-
tion and/or subsequent maintenance operations of
the hydraulic components present on the upper limit
of the appliance.
Install the appliance to walls without skirting boards
and/or projections.
Any installation types/methods which differ from
those specified must be assessed on an individual
basis and must comply, without fail, to the provisions
specified above.
Where possible, we recommend leaving adequate
space, behind the appliance, in order to facilitate
subsequent inspection and maintenance opera-
tions. This measure also facilitates assembly of
the structure and the various connections.
The installation area must comply with the following character-
istics:
- Optimal room temperature: approximately 22-25 °C
- Room height: min 250 cm
- Walls: straight and level where possible.
- Flooring: tiled or laid; in any case, it must be waterproof;
this includes the front area of the appliance.
With the sauna module, the flooring must not be plastic
or carpeted.
NOTE: with models equipped with water jets, we recommend plac-
ing a collection pit at the centre of the installation area (Pr) designed
to deal with water leakages in the event of faults or malfunctioning;
with this aim in mind, the floor must be sloping (see
The supports (feet) of the appliance frame, present across the
entire surface, must always rest completely against the floor, and
subsequently conform to dimensions.
8
1 and 2).