Setup - Renkforce 1712590 Bedienungsanleitung

Never place the garden pump in or under water, there is a risk of death due to an electric shock! Never
place the garden pump in a flood-prone area.
The garden pump can be screwed on the two openings in the stand (3) on a suitable horizontal surface.
Use appropriate screws and wall plugs, depending on the surface. Always ensure that the garden pump is
stable during the operation.
• In outdoor temperatures equal to or below 0 °C, the water freezes in the garden pump, leading to its destruction
and the loss of warranty/guarantee!
Therefore, empty the garden pump on time. To do this, remove all hoses from the garden pump and empty the
garden pump. Store the garden pump in a dry and frost-free place (for example in a cellar).

9. Setup

• Make sure that the garden pump is switched off (on/off switch (1) to the position "O") and disconnected from the
mains cable (mains plug pulled out).
• If not already done, fill the suction hose with clear water. Connect the suction hose to the suction opening. Use a
coarse filter and a return stop at the end of the suction hose.
1
• Fill the pump with clean water. At the top of the pump, you will find a
filling opening (6). Turn the cover screw counterclockwise and fill with
clear water ( ≥ 1.5 L). Close the filling opening carefully after filling.
• Also check that the drain opening (4) is tight.
• For example, connect your garden irrigation system to the outlet
opening (7).
• Plug the mains plug (2) into a proper protective contact mains plug.
2
(For information only, pictures of the garden pump may differ)
23