Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
7. Cleaning
CAUTION!
Disconnect the unit from the power supply (unplug!) before cleaning.
The unit is not designed to be rinsed with running water.
Do not use a pressure washer to clean the device!
Be careful and do not let the water into the unit.
o Clean the device regularly.
o Wipe the housing, cooking surface and control panel with a soft, damp cloth with a
mild, non-abrasive cleaner
o Use only a soft cloth. Never use abrasive cleaning agents that could scratch the
surface.
o Ventilation slots in the bottom part of the device must be always free of dust and
dirt, or cleaned if necessary (e.g. using a brush or blower).
o Never use any cleaning agents containing gasoline or solvents that could damage
the surface.
o After washing the device use a soft, dry cloth to dry and polish the surface
8. Possible Malfunctions
Error code
• The device becomes too hot
(e.g. due to blocked
ventilation slots).
E01
• Parts are damaged (e.g.
transistor).
• The overheating protection
was activated, because the
E02
cookware was empty or
became too hot. The device
switches off.
• Short-lasting power surge or
E03
low voltage.
Cause
Solution
• Clear/unblock ventilation slots.
Let the device cool off for a few
minutes; the device is ready for
operation afterwards. Contact the
retailer in case the error message
is shown again on the digital
display.
• Contact the retailer.
• Remove the cookware from the
hob. Let the device cool off for a
few minutes. The device is ready
for operation afterwards.
• Remove the device from the socket
(pull the plug). Have an electrician
check the power supply installation.
- 39 -
Werbung
Kapitel
Inhaltsverzeichnis
