Installation; Positioning; Electric Connection - Bartscher IK 20TC Gebrauchsanleitung

5. Installation

5.1 Positioning

•
Before the operation unpack the device and remove all package material.
CAUTION!
Never remove the rating plate and any warning signs from the device.
•
Place the device on top of an even, stable, dry, and water-resistant surface which
supports the weight of the device and is not heat sensitive.
•
Never place the device on a flammable surface.
•
Do not place the device near an open flame, electric oven or other source of heat.
•
Do not block or cover the ventilation ducts that allow for air to circulate around the
device. Doing so may lead to overheating of the device.
•
Keep a distance of at least 5 – 10 cm from flammable walls and other objects.
•
Do not place the induction plate near other equipment and objects sensitive to
magnetic fields (e.g. radio, television, etc.).
•
Place the device so that the plug is easily accessible and can be quickly removed
from its socket in case of necessity.

5.2 Electric connection

WARNING!
The device can cause injuries due to improper installation!
Before installation the local power grid specification should be compared
with that of the device (see type label). Connect the device only in case of
compliance!
The device must only be connected to a properly installed single socket
with protective contact.
Never remove the power cable by pulling the cable itself; always grab
the plug housing.
•
The electrical circuit of the socket must be secured to at least 16A. Only connect
the device to a wall outlet; do not use any extension cords or power strips.
- 32 -
Electric shock hazard!