Edirol aUDIO cAPTURE ua-5 Erste Schritte Seite 58

Troubleshooting
Volume from a device connected to the input jacks is
too low
• Are you using a cable that has a built-in resistor?
Use a cable without a built-in resistor (e.g., Roland PCS series).
• Are the Input sensitivity knobs raised appropriately?
Turn the knobs clockwise to adjust the volume. (p. 10)
Guitar sound is too weak
• Connect your guitar to input jack 2.
• Set the Input impedance select switch to Hi-Z (on).
You connected a mic or guitar to an input jack, but the
sound is heard from only one speaker (or one side of the
headphones).
• Set the Input monitor stereo/mono select button to MONO.
Noise is heard during audio playback
• Is a mic or guitar still connected?
If a mic or guitar is connected to the UA-5, disconnect the mic or guitar, and turn the
input sensitivity knob all the way to the left.
Disconnect any audio devices you are not using.
• Noise is sometimes heard in the line input or mic input.
If a USB-compatible MIDI sound module and the UA-5 are connected via USB to the
same computer, and the outputs of the MIDI sound module are connected to the line
input jacks of the UA-5, noise from your computer may be heard via the MIDI sound
module from the UA-5, depending on the computer you are using. If this occurs, you
can either connect the MIDI sound module and the UA-5 in parallel using a self-
powered hub, or connect the MIDI sound module via its serial or MIDI interface.
• In some cases, you may also be able to solve this problem by grounding the chassis of
your computer, or the grounding connector of the AC power supply plug of your
computer. In addition, you can check whether any devices that produce a strong
magnetic field are located nearby, such as a television or microwave oven.
• Also check the troubleshooting item "Sound is interrupted during audio playback."
58