Installing The Asio Driver - Edirol aUDIO cAPTURE ua-5 Erste Schritte

Getting Connected and Installing Drivers (Macintosh)
fig.05-20e_30
5
If a message like
the following is
displayed, click
[Continue]. The
other currently
running applications will exit, and installation will
continue.
6
A dialog box will indicate Installation completed.
Click [Restart] to restart your Macintosh.
7
With the power turned off, use a USB cable to
connect the UA-5 to your macintosh.
8
Set the UA-5's ADVANCE (mode select) switch to
the ON position.
9
Switch ON the UA-5's Power switch.
Connect the AC adaptor to the UA-5's AC adaptor jack, and
insert the AC adaptor's plug into an AC power outlet. Then,
turn on the power of the UA-5.

Installing the ASIO driver

This section explains how to install the ASIO driver that
allows the UA-5 to be used by your sequencer software or
audio editing software. For details on installation and settings
of the ASIO driver, be sure to also read the English-ASIO-
Setting ASIO Driver-E document on the UA-5 Driver CD-
ROM.
The UA-5 cannot play back audio data from the Macintosh's
sound manager (such as audio CDs and alert sounds).
The ASIO driver of the UA-5 supports the following audio
input/output channels.
• Audio input ....... 24/16 bit 1 stereo ch. (2 monaural chs.)
• Audio output..... 24/16 bit 1 stereo ch. (2 monaural chs.)
36
This unit is equipped with a
protection circuit. A brief
interval (a few seconds) after
power up is required before
the unit will operate normally.
ASIO (Steinberg Audio Stream
In/Out Interface)
This is an audio interface
standard promoted by the
Steinberg Corporation. When
the UA-5 is used with ASIO-
compatible software, the
synchronization precision
be improved, allowing a
more sophisticated music
production environment.
will