Edirol aUDIO cAPTURE ua-5 Erste Schritte Seite 16

Getting Connected and Installing Drivers (Windows)
Switching between Advanced mode and Standard driver mode
If you first install both the special driver and the standard driver, you will be able
to switch between Advance and Standard driver modes by operating the UA-5's
ADVANCE (mode select) switch.
* In order for the setting of the ADVANCE (mode select) switch to take effect, you must
exit all sequencer software and other applications that use the UA-5, switch off the UA-5,
then turn it back on again.
Installing the special driver
The installation procedure will differ depending on your system.
Please proceed to one of the following sections, depending on the system you use.
• Windows 2000 users..................................(p. 16)
• Windows Me/98 users..............................(p. 22)
Windows 2000 users
WDM driver and MME driver
The UA-5 Driver CD-ROM contains two types of driver for Windows 2000.
Before you install the driver, select the driver that will be appropriate for the
application you want to use.
WDM driver
You should use this driver if you have specified WDM driver mode for SONAR or
a similar application. This will provide the highest-quality audio performance.
* It is not possible to use 24-bit audio with applications that do not support a WDM driver
mode, such as Cool Edit or Media Player.
MME driver
This driver allows you to use 24-bit audio even from applications that do not have
a WDM driver mode, such as Cool Edit.
* It is not possible to use the MME driver from WDM driver mode of an application such as
SONAR.
It is not possible to install both the WDM driver and the MME driver. You must
select one beforehand, and install only that driver. If after installing one of these
drivers you decide to change drivers, you must first delete the already-installed
driver and then install the new driver. (->Deleting the special driver (p. 63))
16