Edirol aUDIO cAPTURE ua-5 Erste Schritte Seite 56

Troubleshooting
Problems when using the UA-5
Operating system becomes unstable
• Operation becomes unstable when the computer is started up with the UA-5 already
connected
Please start up your computer with the UA-5 disconnected, and then connect the UA-5.
On a computer that uses a USB keyboard, starting up the computer with the UA-5
already connected may cause operation to become unstable. In this case, start up the
computer with the UA-5 disconnected, and then connect the UA-5.
Can't hear sound from the computer
• Is the Sampling frequency select switch set to "96 kHz REC"?
If the sampling frequency is 96 kHz, the Sampling frequency select switch must be
set differently, depending on whether you are recording or playing back. When playing
back at 96 kHz, set the front panel Sampling frequency select switch to 96 kHz PLAY.
In order for the setting to take effect, you must exit all applications, switch off the UA-
5, then turn it back on again. (About the Sampling frequency select switch setting
(p. 11))
• Is it possible that the UA-5's Master volume has been placed at 0 (turned fully
counterclockwise)?
• The UA-5's Sampling frequency select switch may have been set to "96 kHz REC."
With this setting, only recording is possible. Sound from the computer cannot be played
back.
• Have you specified the audio data output destination for your operating system?
You must specify the UA-5 as the audio data output destination for your computer.For
details on how to make this setting, refer to Settings and checking (Windows, p. 30/
Macintosh, p. 30).
• Have you specified the audio data output destination for your playback software?
For some software such as Cool Edit Pro LE, you must specify the UA-5 as the audio
data output destination. For details on this setting, refer to the operation manual for
your application.
56