Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
the product's hot surface.
– In case of any damage to the supply
cable, make sure to call the Authori-
zed Service. The cable must be repla-
ced by the Authorized Service.
– Wiring of the appliance must be per-
formed by the Authorized Service.
H05VV-F type supply cable must be
used.
– Faulty wiring may damage the appli-
ance. Such a damage will not be co-
vered under the warranty.
– The appliance is designed to connect
to 220-240V~ electricty is different
than the value given above, call the
Authorized Service immediately.
– The Manucaturer Firm declares
that its bears no responsibility
whatsover for any kind of da-
mage and loss arising from not
complying
with
– Wiring of the appliance must be per-
formed by the Authorized Service.
The appliance is
– designed to connect to 220-240V~
electricity. If the mains electricity is
different than the value given, call the
Authorized Service immediately. The
appliance is designed for using with
plug ofor fixed connection to the ma-
ins. It is necessary that you install a
double pole switch between the pro-
duct and the electricity supply (ma-
ins), with a minimum gap of 3 mm bet-
ween the switch contacts. (20A rated,
delay function type).
safety
norms!
EN - 11
3.4. GENERAL WARNING AND
PRECAUTIONS
Your appliance is produced in confor-
mity with the relevant safety instruc-
tions relating to electrical appliances.
Maintanance and repair works must be
performed only by Authorized Service
technicians trained by the manufacturer
firm. Installation and repair works, per-
formed without observing the rules may
be dangerous.
The outer surfaces is heated while your
appliance is operating. The elements
heating the inner surface of the oven
and the steam out are extremely hot.
These sections will continue to preser-
ve their heat for certain while even if the
appliance is switched off. Never touch
the hot surfaces. Keep children away.
In order to cook in your oven, the oven
function and temperature setting butt-
tons need to be adjusted and the oven
timer, needs to be programmed. Other-
wise, the oven will not operate.
While the oven door is open, do not pla-
ce anything on it. You may disturb the
balance of the appliance or break the
door.
Werbung
Inhaltsverzeichnis
