Panasonic TY-ST65PE8 Bedienungsanleitung Seite 19

Assembly Procedure
2. Attaching the pedestal tube
1) Place the pedestal tubes
back of the display.
● Locate the nuts inside.
(The side with the nuts comes to the downside.)
2) Fix with the 4 display installation screws
Tightening torque: 1.6 to 2.2 N•m
Note
● Always use the specified holes to attach the pedestal.
● Do not install the display vertically using the pedestal.
3. Attaching the base
1) Insert the base to the pedestal tube.
● The surface with the label goes to the back of the
display.
● Be careful not to drop.
2) Fix the base with 4 base installation screws
● Tighten the base installation screws from the outside
of the pedestal tube.
Tightening torque: 1.2 to 1.5 N•m
3) To stand the display vertically.
● Make sure to hold the display with more than two
people.
(Cont'd)
to fit the holes at the
.
.
Pedestal tube
Nut
Display installation screw
Base installation screw
Base
19