Sony CA-701 Bedienungsanleitung Seite 19

1 Battery attachment
Attaches a BP-L60/L90 Battery Pack, a DC-L1 Battery
Adaptor containing an NP-1B/1A Battery Pack or a
DC-L90 Battery Adaptor containing a BP-90A/90
Battery Pack.
For details on inserting batteries, refer to the Operation
Manual of the DVW-700/700P/700WS/700WSP.
2 PHONES (headphones) jack
Connects stereo headphones with an impedance of 8
ohms.
Note
If you have attached the DC-L90 Battery Adaptor, use
headphones with an L-type plug. In this case, the
BVF-55/55CE Viewfinder cannot be attached to the
CA-701.
3 PHONES LEVEL (headphone output level)
control
Adjusts the headphone volume.
4 AUDIO IN CH-3/CH-4 LINE/MIC/+48 V ON
(audio input channel 3/4 line input/microphone
input/external power supply +48 V on) switches
Specifies the audio source or microphone connected to
the AUDIO IN CH-3/CH-4 connectors.
LINE: Line input audio equipment
MIC: A microphone with internal batteries
+48 V ON: A microphone with an external power
supply
5 AUDIO IN CH-3/CH-4 (audio channels 3 and 4)
connectors (XLR type, 3-pin, female)
Connect an audio source or microphone.
Combined with the AUDIO IN CH-1/CH-2 connectors
on the DVW-700/700P/700WS/700WSP, a total of
four audio inputs are provided.
6 AUDIO OUT (audio output) connector (XLR
type, 5-pin, male)
Outputs the audio signal selected with the MONITOR
switch.
7 SDI OUT 1/2 connectors (BNC-type)
Output two channels of serial digital video/audio
signals.
8 DC IN (DC power input) connector (XLR type,
4-pin, male)
Connect an AC adaptor or an external battery through
a DC output cable. Power input to the CA-701 is
supplied to the DVW-700/700P/700WS/700WSP.
9 DC OUT (DC power output) connector (4-pin)
Supplies power to an optional WRR-860A UHF
Synthesized Diversity Tuner. Use this connector when
an optional battery and the tuner are attached to the
CA-701 and the tuner's power cord cannot reach the
DC OUT connector on the rear of the DVW-700/700P/
700WS/700WSP.
0 Audio channel 3/4 level meters
Indicate the level of the signal input to the AUDIO IN
CH-3 and CH-4 connectors or the level of the audio
playback signal.
!¡ LIGHT switch
Turns the display panel illumination on and off.
ON: Turns the illumination on.
OFF: Turns the illumination off.
!™ AUDIO LEVEL CH-3/4 (audio channel 3/4
recording level) controls
These controls adjust the audio level of channels 3 and
4 when you set the AUDIO SELECT CH-3/4 switches
to MANUAL.
!£ AUDIO SELECT CH-3/4 switches
These switches set the audio level adjustment to
AUTO or MANUAL for channels 3 and 4.
AUTO: Audio level is adjusted automatically.
MANUAL: Audio level is adjusted manually by the
AUDIO LEVEL CH-3 or 4 control.
!¢ MONITOR switches
Select the audio output to the AUDIO OUT connector
or headphones (audio channels 1, 2, 3 or 4).
Use the left switch to select CH 1/2 (audio channels 1
and 2) or CH 3/4 (audio channels 3 and 4), and the
right switch to select ST (two-channel stereo output) or
MONO (single-channel monaural output) for the
selected channels.
5 (E)