Projecting The Picture; Turning Off The Power - Sony VPL-GTZ1 Kurzreferenz

Step 5

Projecting the Picture

1
Turn on both the unit and the
equipment connected to the unit.
2
Press INPUT to display the input
palette on the projection surface.
3
Select the equipment from which you
want to display images.
Press INPUT repeatedly or press M/m/
(enter) to select the equipment from
which to project.
Example: To view the picture from the
video equipment connected to the HDMI
1 connector of this unit.

Turning Off the Power

1
Press the ?/1 (ON/STANDBY)
button.
The message "POWER OFF?" appears.
2
Press the ?/1 (ON/STANDBY) button
again before the message disappears.
The LED indicator turns off.
You can disconnect the AC power cord.
Notes
• Never disconnect the AC power cord while
the unit is turned on.
• The LED indicator does not change when
"Illumination" is set to "Off" on the
Installation menu,
Projecting
You can turn off the unit by holding the ?/1
(ON/STANDBY) button for about 1 second,
instead of performing the above steps.
For more information, refer to
"Projecting" in the Operating Instructions
contained in the supplied CD-ROM.
19
GB