Cancelling The Programme - Electrolux GA60GLICSP Benutzerinformation

16 www.electrolux.com
The display shows the programme
duration.
4. Set applicable options if desired.
5. Press
• The indicator of the running phase
is on.
• The programme duration counts
down in minutes.
Starting a programme with
delay start
1. Set a programme.
2. Press
shows the desired delay time (from 1
to 24 hours).
The indicator
3. Press
The remaining time counts down in
hours. The final hour is displayed in
minutes.
When the countdown is complete, the
programme starts and the indicator of the
running phase is on. The indicator
off.
Opening the door while the
appliance operates
Opening the door while a programme is
running stops the appliance. It may affect
the energy consumption and the
programme duration. After closing the
door, the appliance continues from the
point of interruption.
If the door is opened for
more than 30 seconds
during the drying phase, the
running programme ends. It
does not happen if the door
is opened by AirDry function.
to start the programme.
repeatedly until the display
is on.
to begin the countdown.
Cancelling the delay start while
the countdown operates
When you cancel the delay start, you
have to set a programme and options
again.
Press and hold simultaneously
until the appliance is in programme
selection mode.

Cancelling the programme

Press and hold simultaneously
until the appliance is in programme
selection mode.
Make sure that there is detergent in the
detergent dispenser before you start a
new programme.
End of the programme
When the programme is complete, the
display shows 0:00. The indicator
is
on.
All buttons are inactive except for the
on/off button.
1. Press the on/off button or wait for the
Auto Off function to automatically
deactivate the appliance.
If you open the door before the
activation of Auto Off, the appliance
is automatically deactivated.
2. Close the water tap.
The Auto Off function
This function decreases energy
consumption by deactivating
automatically the appliance when it is not
operating.
The function comes into operation:
• 5 minutes after the completion of the
programme.
• After 5 minutes if the programme has
not started.
and
and
is