Prior To Commissioning - Taski swingo 350B Bersetzung Der Original Bedienungsanleitung

Charging procedure with external battery charger
• Connect the external battery charger with the battery iso-
lating plug of the machine.
Attention:
Make sure that the plug is inserted up to
the stop in order to ensure a good electri-
cal contact.
Notice:
All machine functions are deactivated
during charging.
Charging procedure with (optional) on-board charger
Attention:
The machine must be switched off (main
switch) and the battery disconnection plug
must be disconnected.
• Connect the main cord with a socket (protected by slow
fuse).
• The yellow indicator is constantly lit
until approx. 90% of the battery ca-
pacity has been reached. After-
wards, the indicator flashes until the
battery is fully charged.
• When the charging process is com-
plete, the green indicator is lit.
After charging
• Disconnect the power supply cord from the socket.
• Store away the power cord in the provided compartment.
Attention:
Charging cables transfer high currents. Do
not use the charger if there are any signs
of damage to the plug, cable or device
connection.
Maintenance and care of batteries
Notice:
The care for maintenance-free batteries is
limited to the compliance with the correct
charging processes and correct adjust-
ment of the charging curve.

Prior to commissioning

Brush installation
Before inserting, please check:
• that the brush does not fall below the red marking (bristles)
or 1cm of bristle length.
• the pad for wear and cleanliness before use.
Attention:
Do not use brushes which have reached
their wear limit. The wear limit is indicated
by the length of the red bristle. Do not use
worn or contaminated pads. Use original
TASKI brushes only. Failure to observe
these instructions may result in inade-
quate cleaning results or even floor dam-
age.
• The machine must be switched off.
• Place the machine on the parking
A
support.
A: For traction batteries; use the
parking support on the right
B: For lithium-ion batteries; use the
parking support on the left
B
• Screw on the triangular handle (1)
1
and remove the brush holder (2).
2
• Insert the brush into the brush hous-
ing.
• Press the brush upwards with your
right hand so that it is accepted by
the centring hexagon in the brush
housing.
• Reattach the brush holder (1) and
2
screw the triangular handle (2) shut
again.
1
EN
69