Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
2. INSTALLATION
IMPORTANT
2.1. PRELIMINARIES
Remove the protective film from the outer surfaces.
Carefully clean the inside of the appliance with warm water and neutral soap, then rinse and dry thoroughly.
ATTENTION !
Place the appliance in its permanent position and adjust the feet so that it is perfectly aligned. Make sure that
minimum clearance is observed, to allow use and maintenance operations.
2.2. CHECKS
Check that there are no sources of heat in the close vicinity.
Check that the electricity supply available complies with the rating plate on the appliance, and especially that
the mains voltage is within a tolerance of +/-10% of the value required.
ATTENTION !
THE MANUFACTURER DECLINES ALL RESPONSIBILITY IF INSTALLATION
IS NOT CARRIED OUT BY PROPERLY QUALIFIED PERSONNEL OR IF THE
INSTRUCTIONS IN THIS MANUAL ARE NOT OBSERVED
DO NOT WASH WITH DIRECT JETS OF WATER AT HIGH PRESSURE AS
THIS COULD CAUSE INFILTRATION WHICH COULD COMPROMISE
PROPER OPERATION OF THE APPLIANCE OR THE SAFETY SYSTEM
THE MANUFACTURER DECLINES ALL RESPONSIBILITY FOR ANY
DAMAGE CAUSED BY FAILURE TO EARTH THE APPLIANCE
Pagina 23 di 52
Werbung
Inhaltsverzeichnis
Fehlerbehebung
