Trouble Shooting - Whirlpool AGB 473/WP Bedienungsanleitungen

5. TROUBLE SHOOTING

IMPORTANT
5.1. ALARMS
The instruments are provided with an internal control that checks the state of the memory. The flashing "E2"
alarm signals a fault in the memory. If the alarm continues, call the after-sales service.
The "E0" and "E1" probe alarms cut in a few seconds after the fault occurs on the probe; they automatically cut
out a few seconds after the second probe starts operating normally. Before replacing the probe, check the
wiring.
ATTENTION !
THE OPERATIONS DESCRIBED ARE THE FULL RESPONSIBILITY OF THE
PERSONNEL CARRYING THEM OUT. IT IS COMPULSORY TO EMPLOY AN
AUTHORIZED AFTER-SALES SERVICE ORGANIZATION IN POSSESSION OF
THE REQUISITES NEEDED TO CARRY OUT OPERATIONS THAT WILL
RESTORE THE FUNCTIONS OF THE APPLIANCE
IN THE EVENT OF PROBLEMS (SMELL OF BURNING, ODD NOISES, ETC.)
STOP THE APPLIANCE IMMEDIATELY, UNPLUG FROM THE MAINS AND
CALL AN AUTHORIZED AFTER-SALES SERVICE ORGANIZATION.
Pagina 30 di 52