Check List - EdilKamin IDROPELLBOX Installations-, Betriebs- Und Wartungsanleitung

CONSIGLI PER POSSIBILI INCONVENIENTI
8 ) Signalling: H2O TEMPALARM
Problem: Shuts down due to water temperature being higher than 90 °C.
An e cessive temperature ma occur ecause o the ollo ing
s stem too small as the DEA E to activate the EC
loc age clean the e changer pipes, the com ustion cham er and the smo e outlet.
Problem: Turns off for lack of depression
lo ma
This ma also e the case i there is a pro lem ith air inta e or smo e e traction, or i the
com ustion cham er is loc ed or the o sensor dirt
Also chec that the o sensor limits are ithin the parameters.
The depression alarm ma also e signalled during ignition, i the chimne
speci cations or the chimne
10) Signalling: "Battery check"
Problem:
Actions: The u er atter o the control oard needs changing DEA E .
11) Problem: Remote control not working
Actions:
closer to the receiver o the oiler- replace
chec the atter and i necessar , replace it.
12) Problem: synoptic panel is off:
Actions: chec the po er ca le connection,
chec use on po er ca le ,
chec connection o
13) Problem: Water is not hot enough:
Actions: clean the hearth e changer
NOTA
All signals/warnings remain shown until you intervene on the remote control, by pressing the button 0/1.
It is important to tell the Dealer exactly what the panel signals.
Positioning and installing
Commissioned a quali ed DEA E
oom ventilation
nl the oiler- replace outlet passes through the smo e channel/chimne
The smo e channel has a ma imum o 2 curves, a ma imum 2 horizontal metres
Chimne pot that is high enough to avoid do ndra t areas
The discharge pipes are made o a suita le material stainless steel is recommended
hen using an amma le materials e.g. ood , all precautions have een ta en to prevent a re hazard
Use
ood qualit , dr pellets are used
The chimne pot and ash compartment are clean and ell positioned
The door is closed properl
The com ustion cham er is inserted properl into the relevant compartment
REMEMBER TO VACUUM THE COMBUSTION CHAMBER BEFORE EACH IGNITION
Should ignition fail, DO NOT re-ignite until you have emptied the combustion chamber.
intervenes i the o sensor detects insu cient com ustion .
e insu cient i there is a hatch open or the hatch is not per ectl sealed e.g. seal a ed .
ue and chimne pot are clogged.
at ca le to s noptic panel

CHECK LIST

ho has issued the arrant and maintenance manual
unction
clean ith dr air .
ue
- 40
-
ue does not compl ith