HP LASERJET PROFESSIONAL M1210 MFP Serie Installationshandbuch Seite 10


Windows wireless installation
EN
Note: Some virus-checking and firewall software might prevent you from installing the
product software.
Before starting the installation, verify that the wireless access point is working correctly,
the computer is connected to the network, and the product is turned on.
• If there is not a solid blue light on the top of the product, go to process A.
• If there is a solid blue light on the top of the product, to go process B.
A.
1. Connect the USB cable between the computer and the product. The HP Smart Install
program (see picture above) should start automatically within 30 seconds. Note:
If HP Smart Install does not start automatically, AutoPlay might be disabled on your
computer. Browse My Computer and double-click the HP Smart Install CD drive.
Double-click the SISetup.exe file to run the program to install the product. If you
cannot find the HP Smart Install CD drive, use the software CD to install the product.
2. Follow the onscreen instructions.
3. When prompted to select a connection type, select the Configure to print over
Wireless Network option.
B.
1. From the product control panel, press the Setup button, use the arrow buttons
to select the Reports menu, and then press the OK button. Use the arrow buttons
to select the Config report option, and then press the OK button.
2. At the computer, open a Web browser, type the product IP address (from the
configuration report page) in the address field, and press the Enter key to open
the product embedded web server page.
3. Click the HP Smart Install tab, and then click the Download button.
4. Follow the onscreen instructions.
HP Smart Install