MA lighting onPC command wing Bedienungsanleitung Seite 42

On / Off Switching
Connect / Installation
Download grandMA2 onPC -software from MA – Homepage.
MA onPC fader wing needs grandMA2 onPC V 2.7 and higher
(grandMA1 onPC is not applicable).
Install the software „grandMA2 onPC" on your Windows – PC or notebook. Minimum requirements
you will find at: www.malighting.com .
switch on your PC or notebook and start MA onPC.
Connect the MA onPC fader wing to your PC or notebook via the provided USB cable. Use port
USB/PC. For connecting MA onPC command wing use port USB
Connect the power supply. The MA onPC fader wing is equipped with a automatic PSU (90 -264 V ∼//
Connect your PC or notebook with the other hardware. Such as shown on previous page.
50 – 60Hz). PAY ATTENTION TO DETAILS ON PAGE 28 AND 35
ON
Set the mains switch on the rear side of the fader wing to „I".
Fader- and DMX -configuration:
From grandMA2 onPC version 2.7.X: Faders of the onPC fader wing always have the number range
16 – 30. DMX – outputs are fixed to universes 3 till 6. This version supports 1 MA onPC fader wing or 1x
MA onPC command wing + 1x MA onPC fader wing.
grandMA2 onPC version 2.8 and higher: Every fader wing can be assigned with a ID (1 or 2); the fader
wing will "keep this ID – number in mind". Ex works fader wings are always assigned to ID1. Fader
wings with the same ID runs synchronize and are displayed in the SETUP – menu as one flashing
row. A click on this row opens an assign - pop-up.
DMX – outputs can be assigned user-defined in the SETUP – menu of the onPC. Also fader numbers
can be assigned block by block (1-15, 16-30 etc.).
This version supports 1x or 2x MA onPC fader wing or 1x or 2x MA onPC fader wing and 1x MA onPC
command wing.
Note: Flashing executor buttons indicates, that the position of this fader does not correspond with the
position of the virtual fader (internally stored fader position) of the onPC. Position of the virtual fader is
relevant for value output. After first movement of the command wing –fader (the "real" fader), this
position is relevant for value output.
OFF
Set the mains switch on the rear side of the MA onPC fader wing to „O".
Note: Disconnecting the MA onPC fader wing from your PC or notebook is always possible –
however DMX –output is interrupted immediately.
Show is always stored on your PC or notebook, not on your MA onPC fader wing.
Update only possible with a PC or notebook and grandMA2 onPC.
For longer non use disconnect all cables.
/CMD.
MA onPC
command wing
1
MA onPC
fader wing
Data
Transport
Safety
instructions
Safety and
environment
Quickstart
Connect
Quickstart
ON / OFF
Maintenance
Conformity
40