Assembling The Display; Support - Seca 685 Bedienungsanleitung Und Garantieerklärung

Assembling the display

support

You need the following fastenings for this assembly
step:
4 x B 3.5 x 9.5
1. Insert the loose end of the display cable in the top
cross-piece so that the connector points towards
the right-hand side part.
Caution!
Risk of tripping
If the display cable is pulled too far through the
upright, it forms a loop which patients and users
may trip over.
►
Do not remove the cable ties on the display
cable. The cable ties determine the length of
the display cable. This allows it to be conve-
niently connected to the electronics box
without forming a loop.
2. Push the display cable through the upright until the
connector protrudes at the bottom end of the up-
right.
Before you really get started ... • 77
English
2 x cap