Vitek Cobra VT-1805 R Betriebsanweisung Seite 6

ENGLISH
the dust bag (17 or 23) at its place (Pic. 7).
• Close dust bag compartment cap (9).
Notice: It is recommended to clean the dust
bag every time after vacuum cleaner usage.
Inlet filter (16) removing and cleaning
(Pic. 7)
• Press the lock (8) and open the cap (9).
• Pull the inlet filter (16) up.
• Pull filter upward in lukewarm water and dry
the filter completely.
• Insert inlet filter (16) at its place and close
the cap (9).
Notice: Wash inlet filter (16) regularly.
Inlet filter cleaning
• Open inlet filter cap (21).
• Take filter (20) out, wash it by warm water
and dry.
• Put the filter (20) into the cleaner and close
the cap (21) (Pic. 8).
Notice: filter (20) should be cleaned at least
once a year or when it becomes visible solid.
Vacuum cleaner housing
• Swap the vacuum cleaner housing with wet
cloth.
• Do not let any liquids inside the housing.
• Do not use dissolvent and abrasive deter-
gents to clean he surface of the housing.
Storage
Use special brush compartment (22) while
storing the vacuum cleaner.
Technical characteristics:
Voltage requirement:
Power requirement:
Suction power:
Dust bag capacity:
Vt-1805.indd 6 Vt-1805.indd 6
The manufacturer reserves the right to
change the device's characteristics without
prior notice.
Service life - no less than 5 years.
GUARANTEE
Details regarding guarantee conditions can
be obtained from the dealer from whom the
appliance was purchased. The bill of sale or
receipt must be produced when making any
claim under the terms of this guarantee.
230 V ~ 50 Hz
1600 W
300 W
2 L
6
This product conforms to the
EMC-Requirements as laid down
by the Council Directive 89/336/
EEC and to the Low Voltage
Regulation (73/23 EEC)
26.09.2006 10:28:13 26.09.2006 10:28:13