Adler europe AD 7705 Bedienungsanweisung Seite 7

19.Always turn the fan heater off and set the thermostat dial to minimum before removin
the power plug from the socket.
20.Never use the fan heater in high humidity rooms – bathroom, shower room, swimming
pools etc. The humidity can cause short circuit, and effect in damaging the device.
21.The operating fan heater needs to be under supervision and in sight all the time. If you
are leaving the room with the fan heater, always turn the fan heater off. If the fan heater is
not used, the power plug has to be removed from the power outlet.
22.Do not connect the fan heater to the automatic switching device, for example
temperature controlling device or time switch.
23.Flammable materials, for example furniture, bedclothes, paper, clothes, curtains should
be kept at least one meter from the fan heater.
24.Do not cover the device or put any objects on it while it is operating. Do not use the
device to dry clothes.
25.The heating surfaces can heat to a temperature of 60 °C or higher. The fan heater
should be in a place that children and animals do not have access to.
26.The device is not intended to be installed or used in vehicles.
27.Some parts inside the device can be hot or cause sparking. Do not use the fan heater in
places, where gasoline, paints or other flammable materials are used or stored.
DESCRIPTION :
1. Control Led's
5.Feets
Note: the first time you can receive the smell of burning. This is normal, and after a short time the smell should disappear .
1. Turn on the power cord (4 ) into an electrical outlet .
2. Turn the thermostat knob (3 ) setting the desired temperature .
3. Select the operation mode of convector heater with switches (2):
- Enabled switch 750W (low power )
- Enabled switch 1250W ( average power )
- Switch is 750W and 1250W switch ( high power )
4. When convector heater reaches the desired temperature lights (1) go out. The heater will switch on and off to maintain a constant
temperature.
5. If the thermostat knob (3 ) will be set to minimum , the heater will maintain the ambient temperature above 0°C
6. You can run the turbo mode and the fan blowing using switch.
Cleaning:
Always unplug the heater from the wall socket and allow it to cool down before cleaning.
Clean the outside of the heater by wiping with a damp cloth and
buff with a dry cloth.
Do not use any detergents or abrasives and do not allow
any water to enter the heater.
TECHNICAL DATA
Voltage: 220-240V 50Hz
Power: 1800-2000W
To protect your environment: please separate carton boxes and plastic bags and dispose them in corresponding waste bins. Used appliance should
be delivered to the dedicated collecting points due to hazarsous components, which may effect the environment. Do not dispose this appliance in the
common waste bin.
ALLGEMEINE SICHERHEITSVORSCHRIFTEN LESEN SIE AUFMERKSAM WICHTIGE
ANWEISUNGEN BEZÜGLICH DER SICHERHEIT DER BENUTZUNG BEWAHREN SIE DIESE
Bei Verwendung des Gerätes zu gewerblichen Zwecken werden die Garantiebedingungen
geändert.
1. Vor Inbetriebnahme der Nutzung lesen Sie diese Bedienungsanleitung und befolgen Sie alle
aufgeführten Hinweise. Der Hersteller haftet nicht für Schäden, die auf
nichtbestimmungsgemäße Verwendung oder unsachgemäße Benutzung zurückzuführen sind.
2. Das Gerät ist ausschließlich für den Hausgebrauch ausgelegt. Verwenden Sie es nicht für
andere, nichtbestimmungsgemäße Zwecke.
2. Switches
6. Screws
DEUTSCH
FÜR DIE ZUKUNFT AUF
3.Thermostat
7. Vents
7
4.TURBO Fan