EuroLite LED KLS-180 Bedienungsanleitung Seite 27

Sound control
Via the integrated microphone the unit can perfectly reproduce the show programs to the rhythm of the
music (sufficient bass provided).
1 Press the MENU button so many times until Soun is indicated in the display. Confirm with the ENTER
button. Use the buttons UP and DOWN to select the desired show program (So01~So03). Confirm with
the ENTER button.
2 Press the MENU button so many times until SPEE is indicated in the display. Confirm with the ENTER
button. Use the buttons UP and DOWN to adjust the running speed of the program from SP 01 (slow) to
SP 09 (fast). Confirm with the ENTER button.
3 Press the MENU button so many times until SEnS is indicated in the display. Confirm with the ENTER
button. Use the buttons UP and DOWN to Adjust the microphone sensitivity to the volume of the music
(SE 01 = low, SE 09 = high).
4 If you enable the silent scene mode (on setting) in menu item SILE, the LEDs will switch off if the volume
is too low or if there is no sufficient bass beat. If you disable this mode (off setting) the LEDs remain on
during periods without music.
Individual color mix
In the color mode Colo each of the 4in1 LEDs can be individually adjusted for intensity. The device will
constantly emit the set color.
1 Press the MENU so many times until Colo is indicated in the display. Confirm with the ENTER button.
2 Now the display indicates the letter r for the color red and the corresponding intensity value. Use the
buttons UP and DOWN to adjust the desired value.
3
Confirm with the ENTER button. Now the color green can be adjusted, then blue and white.
Total brightness
Menu point diMM allows the adjustment of the total brightness for all stand-alone operating modes: Stat,
Auto, Soun, Colo.
1 Press the MENU button so many times until diMM is indicated in the display. Confirm with the ENTER
button.
2 Use the buttons UP and DOWN to adjust the desired brightness (dI 01 = dark, dI 09 = bright). Confirm
with the ENTER button.
Strobe LEDs
In Stro mode, you can set the strobe function of the white strobe LEDs.
1. Press the MENU button so many times until Stro is indicated in the display. Confirm with the ENTER
button.
2. Use the buttons UP and DOWN to choose on (strobe function on) or oFF (strobe function off). Confirm
with the ENTER button.
Interconnecting several devices (master/slave operation)
Several devices may be interconnected (max. 32). Then all slave units can be synchronized and controlled
with the master unit without the need for a DMX controller. The devices must be set to the corresponding
operating modes.
1 Configure all slave units before connecting the master unit: Press the MENU button so many times until
SLAU is indicated on the display. Confirm with the ENTER button.
2 Connect the DMX output of the master unit to the DMX input of the first slave unit. Then connect the
DMX output of the first slave unit to the DMX input of the second slave unit, etc. until all units have been
connected in a chain. Make sure the master unit is the first in the chain. Do not connect a DMX controller
to the DMX input of the master unit.
3 Set the master unit to the desired operating mode. The interconnected devices will now operate
synchronously.
27/34 00126056, Version 1.0